Book excerpt: "This new curriculum standard for the Level 2 - General Machinist for the Machining and Tooling trades is based upon the on-the-job performance objectives, located in the industry approved training standard. The curriculum is organized into 8 reportable subjects. The Program Summary of Reportable Subjects chart summarizes the training hours for each reportable subject. The curriculum identifies only the learning that takes place off-the-job. The in-school program focuses primarily on the theoretical knowledge and the essential skills required to support the performance objectives of the Apprenticeship Training Standards. Employers/Sponsors are expected to extend the apprentice's knowledge and skills through practical training on the work site."--Document.